Your cart is empty

High Temperature Hot Melt Glue Gun 20W

PayPal Acceptance Mark



1. The heater component of the product is made of positive temperature coefficient electric resistance (PTC). It's heating very fast and automatic of control temperature. The hot melt glue gun can use normally in 100V to 240V power supply, be free from the electric voltage motion to limit, inside place the fuse, use more safe.

2. The electricity strength was not to broke through of the product insulate while switch on electricity 3750 Vs/minute.


1. The toy model;

2. Artificial flowers, Christmas tree;

3. Decorations, the metals product;

4. The wood product, card paper;

5. Electronics circuit plank etc.


1. This series product can use the diameter from 10.8mm to 11.8mm of melt glue.

2. Insert the glue from the glue gun tail, sent to the gun tube, put on the power supply to preheating from 5 to 8 minutes, button up to move the trigger and can extrude the melt glue, and can control the melt glue quantity.

3. while it's working, if the melt glue is inexhaustibility in one time, then the melt glue need not take out. Put on the power supply to preheating 5 to 8 minutes when it using next time.


1. The hot melt glue gun is a high temperature product. If the customer used the size of the melt glue that types not agree with, it would cause the melt glue reflux and damaged the glue guns.

2. Do not touch the nozzle area and melted glue, for they are high temperature when they working. Forbid to use in the situation that easy fuel and explode easily.

3. While it's working, do not raise it, and the nozzle can't upward. If the glue gun does not work continuously for 15 minutes, please cut off the power supply. In order to prevent the melt glue to pour from the glue gun to damage it as all.

4. The new glue gun while using for the first time may appear to emit few smoke, this is the normal phonomenon. After the glue gun is using 30 minutes, the smoke will auto cancellation.

5. Should usually keep the slippery piece of the glue gun tail sweep, for the melt glue can send into the gun tube smoothly, forbid to pull out the melt glue from the glue gun tail parts.

6. The glue gun should keep dry in the airiness of place, out of the reach of children.

7. This tool at not use must place at it of support up.

Please use 0.71 x 26.5cm Glue Sticks, Link

Add to Cart:

  • Shipping Weight: 0.18kg
  • 76 Units in Stock